Electric AutoSampler™ Series Belt Sampler The CLEAN SWEEP® AutoSampler™ represents the state-of-the-art in sweep sampler design. The CLEAN SWEEP® AutoSampler™ is a top-of-the-belt sweep sampler designed to mount to the top chord of a conveyor and normally retrofit to the conveyor truss between existing 35-degree idlers. JBLCo provides complete, pre-assembled and pre-tested equipment directly from JBLCo’s factory. The sampler removes each sample increment from the loaded, moving conveyor with a single 360-degree rotation of an open faced Divider/Sweep (or cutter) in a plane perpendicular to material flow. The sample increments are then delivered to save sample containers or to optional secondary sub-systems. The sampler is monitored during and between sample increments (or cuts) to detect any errors that could prevent sampling or interfere with the conveyor.
CUT CYCLE: CLEAN SWEEP® samplers employ an open faced rotating Divider/Sweep (cutter) operating in a 360-degree arc perpendicular to material flow on the belt conveyor to divide and sweep sample increments from the moving, loaded conveyor.

	1. Parked Position				2. Cut Cycle Begins
		Cutter positioned approximately off edge of conveyor blocks sample discharge and prevents contamination.				Electric drive powers cutter rotation; spring mounted impact idlers eliminate sag.

	3. Sample Increment Divided			4. Sample Increment Ejected
		Scooping angle fully contains each increment in cutter; complete, visually verifiable removal.			Cutter stops at the original parking position.